PSA Nitrogen generator gets N2 by pressure swing adsorption principle at normal temperature using clean compressed air as raw material and carbon molecular sieve as adsorbent. Because of the different adsorption of oxygen and nitrogen on carbon molecular sieve surface as well as different diffusion rate through the open/close of program control valve; separation of oxygen and nitrogen is achieved and N2 of required purify is created.

• N₂ capacity: 1 ~ 1200 Nm³/h
• N₂ purity: 95% ~ 99.999%
• N₂ Pressure: ≤0.8Mpa
• Dew Point: ≤ -40°C

Visit Nitrogen Generator by Pressure Swing Adsorption for more information.

The compressed air compressor filter into the polymer membrane filters, a variety of gas in the film in the solubility and proliferation of different factors, leading to different gases in the membrane penetration rate in a relatively different. According to the characteristics, various gases can be divided into "rapid gas" and "slow gas". After being compacted and purified (to remove oil, water and dust) the air will enter the membrane separation to separate. First, the O2, CO2 and some vapor will infiltrate into the membrane wall and then exit through the discharge port by air pressure; since the infiltrating speed of N2 is slower, it will flow out from the gas collector at the end of the pressure box and finally enter nitrogen buffer tank.

• Gas Production 1 ~ 1000 Nm³/h
• N₂ Purity 95% ~ 99.9%
• N₂ Pressure ≥ 0.8Mpa
• Dew Point ≤ -40°C

Visit Nitrogen Generator by Pressure Swing Adsorption for more information.